[Free] 2018(Aug) Ensurepass Cisco 400-151 Dumps with VCE and PDF 1-10

Ensurepass.com : Ensure you pass the IT Exams
2018 Aug Cisco Official New Released 400-151
100% Free Download! 100% Pass Guaranteed!

CCIE Data Center (v2.0)

Question No: 1 – (Topic 1)

Refer to the exhibit.

Ensurepass 2018 PDF and VCE

An admin has created a new EPG in an ACI fabric The admin then specified static path binding as shown in exhibit After submitting this policy configuration, the admin noticed that this newly created EPG had the fault shown in the exhibit. Which option is the like explanation of this fault?

  1. The admin incorrectly configured this static path as a quot;trunkquot; when it should have been configured as an access (untaggeD. port.

  2. The encap VLAN configured is not within the allowed range of VLANs as specified by the associated domain.

  3. There is not enough information to determine the cause of the problem.

  4. The admin incorrectly configured this static path to have a deployment immediacy as quot;Immediatequot; when it should have been configured a quot;on-demandquot;

  5. There is not fault. The fault is currently in the soaking state and the fault will automatically clear and everything will work as expected.

Answer: B

Question No: 2 – (Topic 1)

Refer to the exhibit.

Ensurepass 2018 PDF and VCE

ITD is configured as shown on a Cisco Nexus 7000 switch. Why is p.ng to VIP address still not working?

  1. To ping VIP, you must add a probe to the device group.

  2. VIP must be from the same subnet as the ingress interface.

  3. Fail action is set to the wrong mode.

  4. This behavior is normal.

Answer: D

Question No: 3 – (Topic 1)

Which three statements are considered best practice when configuring an NFS appliance port on Cisco UCS? (Choose three.)

  1. Use of the same VLAN for multiple storage protocol traffic is highly recommended to conserve VLAN namespace use.

  2. Configuration of the VLAN tagging on the storage side and on the Cisco UCS side simultaneously is recommended.

  3. If storage and servers are located in the same subnets, then the appliance port VLANs should be allowed on the upstream switch.

  4. Cisco UCS supports Static and Link Aggregation Control Protocol port channels for appliance port configuration. However, no virtual port-channel support.

  5. If storage is configured in active/passive mode and both fabric interconnects require communication to the same controller, then the appliance port VLANs should be a/lowed on the upstream switch.

  6. If storage must be accessed outside of the Cisco UCS domain, then the appliance port VLANs should be allowed on the upstream switch.

Answer: C,E,F

Question No: 4 – (Topic 1)

Which two guidelines and limitations of NetFlow on Cisco NX-OS are true? (Choose two.)

  1. Only Layer 2 NetFlow is applied on Layer 2 interfaces, and only Layer 3 NetFlow is applied on Layer 3 interfaces.

  2. If you change a Layer 2 interface to a Layer 3 interface, the software converts the Layer 2 NetFlow to Layer 3 NetFlow automatica

  3. You must configure a source interface. If you do not configure a source interface, the exporter remains in a disabled state.

  4. The Cisco Nexus 2000 Series Fabric Extender does not support bridged NetFlow.

  5. Valid record name is optional to configure.

Answer: A,D

Question No: 5 – (Topic 1)

On which two features does ITD depend? (Choose two.)

  1. PBR

  2. Netflow

  3. BFD

  4. interface-vlan

  5. WCCP

  6. IP SLA

Answer: A,F

Question No: 6 – (Topic 1)

Which OpenStack project, whose data can be used to provide customer billing, resource tracking, and alarming capabilities across all OpenStack core components, is a component of the telemetry project?

  1. Ceph

  2. Trove

  3. Ceilometer

  4. Heat

Answer: C

Question No: 7 – (Topic 1)

Which three statements are considered best practice when directly connection converged network adapters to the fabric? Choose three.)

  1. If the converged access switches (in the same SAN fabric or in the other) must be connected to each over Ethernet links for the purposes of LAN alternate pathing, then such links must explicitly be configured to include all FCoE VLANs. This configuration ensures to extend the scope of the Spanning Tree Protocol for FCoE VLANs to Cisco Unified Fabric and non Cisco Unified Fabric links.

  2. Cisco UF links must be configured as spanning-tree edge ports.

  3. If MSTP is enabled, a separate MST instance must be used for FCoE VLANs.

  4. Separate FCoE VLANs must be used for FCoE in SAN-A and SAN-B.

  5. A shared VLAN can be used to carry traffic for each virtual fabric in the SAN (for example, VLAN 1002 for VSAN 1, VSAN 2, and so on).

  6. Cisco Unified Fabric links must be configured as access ports and FCoE VLAN must not be configured as a native VLAN.

Answer: B,C,D

Question No: 8 – (Topic 1)

Which platforms support ITD?

  1. Nexus 7000, Nexus 9000, Nexus 6000, and Nexus 5000

  2. Nexus 7000 Nexus 9000, and Nexus 5000 only

  3. Nexus 7000 Nexus 9000 only

  4. Nexus 7000 with F3 line cards only

  5. Nexus 7000, Nexus 9000, and Nexus 6000 only

Answer: A

Question No: 9 – (Topic 1)

Refer to the exhibit.

Ensurepass 2018 PDF and VCE

When specifying subnets under a bridge domain for given tenant, the user can specify the scope of a subnet. Which definition of the public subnet scope is true?

  1. It indicates that this subnet is advertised to the external router by the border leaf.

  2. It indicates that this subnet is advertised to public Internet and must be protected by a firewall.

  3. It indicates that it must be leaked to one or more private networks within ACI fabric.

  4. It indicates that this subnet is advertised to the border leaf in ACI fabric

Answer: A

Question No: 10 – (Topic 1)

Refer to the exhibit.

Ensurepass 2018 PDF and VCE

An admin wants to bring online a new leaf node into their ACI fabric. Before registering the leaf node, the admin checks the current status arid sees this output.

Which option is the reason for the admin to see this output?

  1. The wrong catalog firmware is running on the APIC.

  2. This output is expected until the admin registers the leaf node and assigns it a role.

  3. The leaf node is yet to be physical connected to the fabric.

  4. The DHCP server running on the APIC has failed and thus the leaf node has not been able to obtain an IP address.

  5. This output is expected until the admin registers the leaf node with an ID and name.

Answer: E

100% Ensurepass Free Download!
400-151 PDF
100% Ensurepass Free Guaranteed!
400-151 Dumps

EnsurePass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.