[Free] 2018(July) Ensurepass Cisco 300-101 Dumps with VCE and PDF 251-260

Ensurepass.com : Ensure you pass the IT Exams
2018 July Cisco Official New Released 300-101
100% Free Download! 100% Pass Guaranteed!

Implementing Cisco IP Routing

Question No: 251 – (Topic 7)

A network engineer has set up VRF-Lite on two routers where all the interfaces are in the same VRF. At a later time, a new loopback is added to Router 1, but it cannot ping any of the existing interfaces. Which two configurations enable the local or remote router to ping the loopback from any existing interface? (Choose two.)

  1. adding a static route for the VRF that points to the global route table

  2. adding the loopback to the VRF

  3. adding dynamic routing between the two routers and advertising the loopback

  4. adding the IP address of the loopback to the export route targets for the VRF

  5. adding a static route for the VRF that points to the loopback interface

  6. adding all interfaces to the global and VRF routing tables

Answer: A,B

Question No: 252 – (Topic 7)

Refer to the exhibit. After configuring GRE between two routers running OSPF that are connected to each other via a WAN link, a network engineer notices that the two routers cannot establish the GRE tunnel to begin the exchange of routing updates. What is the reason for this?

Ensurepass 2018 PDF and VCE

  1. Either a firewall between the two routers or an ACL on the router is blocking IP protocol number 47.

  2. Either a firewall between the two routers or an ACL on the router is blocking UDP 57.

  3. Either a firewall between the two routers or an ACL on the router is blocking TCP 47.

  4. Either a firewall between the two routers or an ACL on the router is blocking IP protocol number 57.

Answer: A

Question No: 253 – (Topic 7)

Refer to the exhibit. The command is executed while configuring a point-to-multipoint Frame Relay interface. Which type of IPv6 address is portrayed in the exhibit?

Ensurepass 2018 PDF and VCE

  1. link-local

  2. site-local

  3. global

  4. multicast

Answer: A

Question No: 254 – (Topic 7)

Where can NetFlow export data for long term storage and analysis?

  1. syslog

  2. collector

  3. another network device

  4. flat file

Answer: B

Question No: 255 – (Topic 7)

Your Company trainee asks you, in the context of IPv6 and OSPF, what best describes a type 9 LSA? What should you tell her?

  1. Link LSA

  2. Interarea prefix LSA for ABRs

  3. Router LSA

  4. Switch LSA

  5. Intra-area prefix LSA

  6. None of the above

Answer: E

Question No: 256 – (Topic 7)

Which outbound access list, applied to the WAN interface of a router, permits all traffic except for http traffic sourced from the workstation with IP address 10.10.10.1?

  1. ip access-list extended 200 deny tcp host 10.10.10.1 eq 80 any permit ip any any

  2. ip access-list extended 10

    deny tcp host 10.10.10.1 any eq 80 permit ip any any

  3. ip access-list extended NO_HTTP deny tcp host 10.10.10.1 any eq 80

  4. ip access-list extended 100 deny tcp host 10.10.10.1 any eq 80 permit ip any any

Answer: D

Question No: 257 – (Topic 7)

What is the IPv6 address FF02::2 used for?

  1. all hosts in a local segment

  2. all routers in a local segment

  3. all hosts in a particular multicast group

  4. all routers in an autonomous system

Answer: B Explanation:

To identify all nodes for the node-local and link-local scopes, the following multicast addresses are defined:

  • FF01::1 (node-local scope all-nodes address)

  • FF02::1 (link-local scope all-nodes address)

    To identify all routers for the node-local, link-local, and site-local scopes, the following multicast addresses are defined:

  • FF01::2 (node-local scope all-routers address)

  • FF02::2 (link-local scope all-routers address)

  • FF05::2 (site-local scope all-routers address)

  • Question No: 258 – (Topic 7)

    ALWAYS block the outbound web traffic on Saturdays and Sunday between 1:00 to 23:59

    1. periodic Saturday Sunday 01:00 to 23:59 and IN

    2. periodic Saturday Sunday 01:00 to 23:59 and OUT

    3. periodic Saturday Sunday 01:00 to 11:59 and IN

    4. Absolute Saturday Sunday 01:00 to 11:59 and IN

    Answer: B

    Question No: 259 – (Topic 7)

    Which two reductions are the correct reductions of the IPv6 address 2001:0d02:0000:0000:0014:0000:0000:0095? (Choose two)

    A. 2001:0d02:::0014:::0095

    B. 2001:d02::14::95

    C. 2001:d02:0:0:14::95

    D. 2001:d02::14:0:0:95

    Answer: C,D Explanation:

    We can’t use triple colons (:::) in IPv6 presentation. Also We can’t use double colons (::) twice. You can use it only once in any address because if two double colons are placed in the same address, there will be no way to identify the size of each block of 0s. Remember the following techniques to shorten an IPv6 address:

    • Omit leading 0s in the address field, so :0000 can be compressed to just :0 and :0d02 can be com-pressed to :d02 (but :1d00 can not be compressed to :1d)

    • Use double colons (::), but just once, to represent a contiguous block of 0s, so 2001:0d02:0000:0000:0014:0000:0000:0095 can be compressed to 2001:0d02::14:0:0:95 or 2001:0d02:0:0:14::95

    Question No: 260 – (Topic 7)

    Which two different configuration can you apply to a device to block incoming SSH access? (Choose two)

    Ensurepass 2018 PDF and VCE

    1. Option A

    2. Option B

    3. Option C

    4. Option D

    5. Option E

    Answer: B,C

    100% Ensurepass Free Download!
    Download Free Demo:300-101 Demo PDF
    100% Ensurepass Free Guaranteed!
    300-101 Dumps

    EnsurePass ExamCollection Testking
    Lowest Price Guarantee Yes No No
    Up-to-Dated Yes No No
    Real Questions Yes No No
    Explanation Yes No No
    PDF VCE Yes No No
    Free VCE Simulator Yes No No
    Instant Download Yes No No

    Leave a Reply

    Your email address will not be published. Required fields are marked *

    This site uses Akismet to reduce spam. Learn how your comment data is processed.