[Free] 2018(July) Ensurepass Cisco 300-101 Dumps with VCE and PDF 261-270

Ensurepass.com : Ensure you pass the IT Exams
2018 July Cisco Official New Released 300-101
100% Free Download! 100% Pass Guaranteed!

Implementing Cisco IP Routing

Question No: 261 – (Topic 7)

Which two GRE features can you configure to prevent fragmentation? (Choose Two)

  1. IP MTU

  2. MTU ignore

  3. TCP MSS

  4. UDP windows sizes

  5. MTUD

  6. DF bit clear

Answer: C,F

Question No: 262 – (Topic 7)

Which option is one way to mitigate symmetric routing on an active/active firewall setup for TCP-based connections?

  1. performing packet captures

  2. disabling asr-group commands on interfaces that are likely to receive asymetric traffic

  3. replacing them with redundant routers and allowing load balancing

  4. disabling stateful TCP checks

Answer: D

Question No: 263 – (Topic 7)

Which parameter in an SNMPv3 configuration offers authentication and encryption?

  1. auth

  2. noauth

  3. priv

  4. secret

Answer: C

Question No: 264 – (Topic 7)

Which command must be globally enabled on a Cisco router to support IPv6?

  1. ip routing ipv6

  2. ipv6 unicast-routing

  3. ipv6 routing

  4. ip classless

  5. ipv6 cef

Answer: B

Question No: 265 – (Topic 7)

Refer to the following configuration command.

router(conttg)# ip nat inside source static tcp 172.16.10.8 8080 172.16.10.8 80 Which statement about the command is true?

  1. Any packet that is received in the inside interface with a source IP port address of 172.16.10.8:80 is translated to 172.16.10.8 8:80

  2. Any packet that is received in the inside interface with a source IP address of 172 16 10 8 is redirected to port 8080 or port 80

  3. The router accepts only a TCP connection from port 8080 and port 80 on IP address 172 16 10 8

  4. Any packet that is received in the inside interface with a source IP port address of 172 16 10 8 8080 is translated to 172.16.10.8 80

Answer: D

Explanation: http://www.cisco.com/c/en/us/support/docs/ip/network-address-translation- nat/13772-12.html#topic9

Question No: 266 – (Topic 7)

Which SNMP version provides both encryption and authentication?

  1. SNMPv4

  2. SNMPv2c

  3. SNMPv3

  4. SNMPv1

Answer: C

Question No: 267 – (Topic 7)

What type of IPv6 packet will indicate traffic from single host and single node?

  1. multicast

  2. unicast

  3. broadcast

  4. anycast

Answer: B

Question No: 268 – (Topic 7)

Refer to the exhibit. Based on the output from the show command on RT1 which statement is true?

Ensurepass 2018 PDF and VCE

  1. OSPFv3 uses global IPv6 addresses to establish neighbor adjacencies.

  2. RT1 has a subnet mask of 64 bits.

  3. RT1 has FastEthernet0/0 set as a DR for network type broadcast.

  4. OSPFv3 uses Link-local addresses to establish neighbor adjacencies.

  5. RT1 does not have a global IPv6 address set on FastEthernet0/0.

  6. OSPFv3 uses IPv4 addresses to establish neighbor adjacencies.

Answer: D

Explanation:

OSPFv3 is an updated version of OSPF designed to accommodate IPv6 natively. OSPFv3 uses the multicast address FF02::5 and FF02::6, but like EIGRP it uses its link-local address as the source address in advertisements.

Question No: 269 – (Topic 7)

Refer to the exhibit.

Ensurepass 2018 PDF and VCE

Which option prevents routing updates from being sent to the access layer switches?

  1. DWS1(config-router)# passive-interface default DWS2(config-router)# passive-interface default

  2. ALS1(config-router)# passive-interface default ALS2(config-router)# passive-interface default

  3. DWS1(config-router)# passive-interface gi1/1 DWS1(config-router)# passive-interface gi1/2 DWS2(config-router)# passive-interface gi1/1 DWS2(config-router)# passive-interface gi1/2

  4. ALS1(config-router)# passive-interface gi0/1 ALS1(config-router)# passive-interface gi0/2 ALS2(config-router)# passive-interface gi0/1 ALS2(config-router)# passive-interface gi0/2

Answer: C

Question No: 270 – (Topic 7)

Refer to the exhibit. Which statement is true?

Ensurepass 2018 PDF and VCE

  1. Traffic from the 172.16.0.0/16 network will be blocked by the ACL.

  2. The 10.0.0.0/8 network will not be advertised by Router B because the network statement for the 10.0.0.0/8 network is missing from Router B.

  3. The 10.0.0.0/8 network will not be in the routing table on Router B.

  4. Users on the 10.0.0.0/8 network can successfully ping users on the 192.168.5.0/24 network, but users on the 192.168.5.0/24 cannot successfully ping users on the 10.0.0.0/8 network.

  5. Router B will not advertise the 10.0.0.0/8 network because it is blocked by the ACL.

Answer: E

100% Ensurepass Free Download!
Download Free Demo:300-101 Demo PDF
100% Ensurepass Free Guaranteed!
300-101 Dumps

EnsurePass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.