Ensurepass.com : Ensure you pass the IT Exams
2018 May Cisco Official New Released 200-401
100% Free Download! 100% Pass Guaranteed!
Managing Industrial Networks with Cisco Networking
Question No: 21 DRAG DROP – (Topic 2)
Answer:
Question No: 22 – (Topic 2)
What is the purpose of Spanning Tree Protocol?
-
to prevent routing loops
-
to create a default route
-
to provide multiple gateways for hosts
-
to maintain a loop-free Layer 2 network topology
-
to enhance the functions of SNMP
Answer: D
Question No: 23 – (Topic 2)
EtherNet/IP is an Ethernet implementation of which protocol?
-
CIP
-
Industrial Protocol
-
DeviceNet
-
ControlNet
Answer: A
Topic 3, Install, Replace, and Remove Cables
Question No: 24 – (Topic 3)
Which option best describes a mechanical, ingress, climatic, chemical and electromagnetic environment that is classified as M3 I3 C3 E3?
-
the highest quality
-
office environment
-
severe
-
serviced by multiple cable segments
Answer: C
Question No: 25 – (Topic 3)
With what are APC connectors used?
-
Category 6a cables that need tight radius bends
-
copper network cables in corrosive environments
-
single-mode fiber-optic cables to reduce return loss
-
high-density copper patch panels
Answer: C
Question No: 26 – (Topic 3)
What should be done with unused conductors in copper unshielded or shielded twisted-pair network cables?
-
terminate in their characteristic impedance
-
trim back and properly insulate
-
connect to protective earth
-
splice to a used conductor
Answer: A
Question No: 27 – (Topic 3)
Which characteristic causes multimode fiber-optic cable to differ from single mode?
-
by allowing multiple network services in the same cable
-
shorter maximum network segment length for a given bandwidth
-
a wider variety of available connector types
-
use outdoors as well as indoors
Answer: B
Question No: 28 – (Topic 3)
For which three issues should fiber-optic network segments be tested? (Choose three.)
-
attenuation
-
near-end crosstalk
-
length
-
polarity
-
jitter
-
tensile stress
Answer: A,C,D
Topic 4, Troubleshooting
Question No: 29 – (Topic 4)
You are troubleshooting a connectivity problem and want to isolate the problem. You suspect that a router on the route to an unreachable network is at fault. Which command would you issue to see where the packets stop?
-
router#ping
-
router#tracert
-
router#show ip route
-
router#show cdp neighbors
-
router#traceroute
Answer: E
Question No: 30 – (Topic 4)
At which Layer would you check for spanning tree loops?
-
Layer 1
-
Layer 2
-
Layer 3
-
Layer 4
Answer: B
100% Ensurepass Free Download!
–Download Free Demo:200-401 Demo PDF
100% Ensurepass Free Guaranteed!
–200-401 Dumps
EnsurePass | ExamCollection | Testking | |
---|---|---|---|
Lowest Price Guarantee | Yes | No | No |
Up-to-Dated | Yes | No | No |
Real Questions | Yes | No | No |
Explanation | Yes | No | No |
PDF VCE | Yes | No | No |
Free VCE Simulator | Yes | No | No |
Instant Download | Yes | No | No |